4 thoughts on “Playing with Temperature on the Crossland CC1”

  1. Nice video! I think that with wait (dwell) time 0, it is similar to just a straight pull (otherwise subtract dwell time from total time for shot total).

    What offset (p9) setting are you using?

    What water have you found the best for the CC1? (I like about 50 TDS, near RO pure!)

    My favorite settings are also about 32 seconds, no waits, and p9=-7 and about 202 deg.

    Am using a Baratza Preciso grinder.

    1. The p9 is at the factory setting (we didn’t mess with that at all).

      In general, we use water with 150ppm, the recommended balance for coffee.

      Thanks for sharing your best tested settings! :)

      – Kat

  2. Thanks for the video. It is amazing how a single degree can move you from a good shot to a great shot. I got my CC1dialed in by using a more scientific approach. I bought a scale that goes down to a hundredth of a gram and measured each dose. I combined this with the espro tamper for an exact 30lb tamp. By taking out some of the variables, dialing in the shot was easier.

    Can you do a compare/contrast video of the CC1 and the Silvia? They are in the same range as each other so understanding the pros and cons of each would be great.

    Thanks again.

    1. We do a compare/contrast of them in our Choose Your Own Adventure video, but I’ll put a more detailed one together (we’re also working on a comparison chart for our new site).

      Thanks for the suggestion!
      – Kat

Leave a Reply

Your email address will not be published. Required fields are marked *

nine − 7 =

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>